ZyXEL NBG-418N User Guide - Page 145
Wireless Problems
View all ZyXEL NBG-418N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Chapter 20 Troubleshooting You will lose all of your changes when you push the RESET button. To reset the NBG-418N, 1 Make sure the power LED is on. 2 Press the RESET button for longer than 1 second to restart/reboot the NBG-418N. 3 Press the RESET button for longer than five seconds to set the NBG-418N back to its factory- default configurations. If the NBG-418N restarts automatically, wait for the NBG-418N to finish restarting, and log in to the Web Configurator. The username is admin and password is 1234. If the NBG-418N does not restart automatically, disconnect and reconnect the NBG-418N's power. Then, follow the directions above again. 20.5 Wireless Problems I cannot access the NBG-418N or ping any computer from the WLAN. 1 Make sure the wireless LAN is enabled on the NBG-418N. 2 Make sure the wireless adapter on the wireless station is working properly. 3 Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports the same wireless standard as the NBG-418N. 4 Make sure your computer (with a wireless adapter installed) is within the transmission range of the NBG-418N. 5 Check that both the NBG-418N and your wireless station are using the same wireless and wireless security settings. 6 Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the NBG-418N. 7 Make sure you allow the NBG-418N to be remotely accessed through the WLAN interface. Check your remote management settings. • See Chapter 6 Wireless LAN for more information. I cannot access the Web Configurator after I switched to a non-router mode. NBG-418N User's Guide 145