ZyXEL P-2812HNU-F1 User Guide - Page 25
Table 1, Color, Status, Description - ip address
View all ZyXEL P-2812HNU-F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Chapter 1 Introduction Table 1 LED Descriptions (continued) LED COLOR STATUS DESCRIPTION PHONE1-2 Green On Blinking A SIP account is registered for the phone port. A telephone connected to the phone port has its receiver off of the hook or there is an incoming call. Orange Off On Blinking A SIP account is registered for the phone port and there is a voice message in the corresponding SIP account. A telephone connected to the phone port has its receiver off of the hook and there is a voice message in the corresponding SIP account. The phone port does not have a SIP account registered. INTERNET Green On The Device has an IP connection but no traffic. Your device has a WAN IP address (either static or assigned by a DHCP server), PPP negotiation was successfully completed (if used). Blinking The Device is sending or receiving IP traffic. Off The Device does not have an IP connection. Red On The Device attempted to make an IP connection but failed. Possible causes are no response from a DHCP server, no PPPoE response, PPPoE authentication failed. WAN Green On This light applies when the Device is in Ethernet WAN mode. The Device has an Ethernet connection with a device on the WAN. Blinking Off The Device is sending or receiving data to/from the Ethernet WAN. The Device does not have an Ethernet connection with the WAN. DSL Green Orange On Blinking On The VDSL line is up. The Device is initializing the VDSL line. The ADSL line is up. Blinking Off The Device is initializing the ADSL line. The DSL line is down. ETHERNET1 Green -4 (Giga Ethernet) Orange (Fast Ethernet) POWER Off Green On Blinking On Blinking On The Device has a successful 1000 Mbps Ethernet connection with a device on the Local Area Network (LAN). The Device is sending or receiving data to/from the LAN at 1000 Mbps. The Device has a successful 10/100 Mbps Ethernet connection with a device on the Local Area Network (LAN). The Device is sending or receiving data to/from the LAN at 10/100 Mbps. The Device does not have an Ethernet connection with the LAN. The Device is receiving power and ready for use. Blinking The Device is self-testing. Red On The Device detected an error while self-testing, or there is a device malfunction. Off The Device is not receiving power. P-2812HNU(L)-Fx Series User's Guide 25