Home » eMachines Manuals » Desktops » eMachines T5226 » Manual Viewer

eMachines T5226 User Guide - Page 66

Laser compliance statement, Digital audio output statement, Radio device regulatory notice, General

UPC - 827103130355

Add to My Manuals
Save this manual to your list of manuals

Page 66 highlights

Appendix A: Regulations and safety notices device. In order to operate within the limits for compliance with Telecom's specifications, the associated equipment shall be set to ensure that automatic calls to different numbers are spaced such that there is not less than 5 seconds between the end of one call attempt and the beginning of another. 5 This equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service. 6 This device is equipped with pulse dialing while the Telecom standard is DTMF tone dialing. There is no guarantee that Telecom lines will always continue to support pulse dialing. 7 Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to bell tinkle or noise and may also cause a false answer condition. Should such problems occur, the user should NOT contact the telecom Fault Service. 8 This equipment may not provide for the effective hand-over of a call to another device connected to the same line. 9 Under power failure conditions this appliance may not operate. Please ensure that a separate telephone, not dependent on local power, is available for emergency use. Laser compliance statement The CD or DVD drive used with this computer is a laser product. The CD or DVD drive's classification label (shown below) is located on the drive. CLASS 1 LASER PRODUCT CAUTION: INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO BEAM. Digital audio output statement The optical connector contains no laser or light emitting diode (LED) more than Class I. Radio device regulatory notice Note: Below regulatory information is for models with wireless LAN and/or Bluetooth only. General This product complies with the radio frequency and safety standards of any country or region in which it has been approved for wireless use. Depending on configurations, this product may or may not contain wireless radio devices (such as wireless LAN and/or Bluetooth modules). Below information is for products with such devices. 56

Section	Page
Contents	9
Checking Out Your Computer	11
About this guide	12
Product Registration	12
Front	13
Back	14
Setting Up and Getting Started	17
Working safely and comfortably	18
Avoiding discomfort and injury from repetitive strain	18
Preparing power connections	19
Protecting from power source problems	19
Checking the voltage selection	20
To set the voltage selection switch:	20
Connecting to a broadband modem or network	21
To connect to a broadband modem or to an Ethernet network:	21
Connecting a dial-up modem	21
To connect the modem:	21
Using the World Wide Web	22
Connecting to a Web site	23
To connect to a Web site:	23
Downloading files	24
To download files or programs from a Web site:	24
Ethernet networking	25
Wired Ethernet networking	25
Ethernet, Fast Ethernet, or Gigabit Ethernet	25
Using a router	25
Example router-based Ethernet network	25
Equipment you need for a router-based Ethernet network	26
Determining if an Ethernet card is already installed on your computer	27
Setting up wired Ethernet network hardware	27
Making sure your broadband connection works	27
Installing Ethernet cards and drivers	27
Connecting network cables	28
Setting up a network using a router	28
To set up a network using a router:	29
Establishing your Ethernet network connection	30
Naming the computers and the workgroup	30
Configuring the TCP/IP protocol	30
Using a DHCP server	30
Configuring your router	30
Testing your network	30
Adding a printer to your network	31
Sharing resources	31
Sharing drives and printers	31
Sharing drives or folders	31
To share drives or folders:	31
Un-sharing drives and folders	32
To un-share drives or folders:	32
Using the network	33
Creating a shortcut to a network drive	33
To map a network drive:	33
Opening files across the network	33
To open files across the network:	33
Copying files across the network	34
To copy files across the network:	34
Printing files across the network	34
To print files across the network:	34
Troubleshooting	35
First steps	36
Troubleshooting	36
Add-in cards	37
The computer does not recognize an add-in card	37
Audio	37
CD or DVD drives	37
DVD drives	37
Ethernet	37
You cannot see the other computers on your network	37
The computer does not recognize an add-in Ethernet card	38
Your Ethernet network is running slower than you expect	38
Expansion cards	39
The computer does not recognize an expansion card	39
File management	39
A file was accidentally deleted	39
To restore deleted files:	39
Hard drive	39
You see an “Insufficient disk space” error message	39
You see a “Data error” message	40
The hard drive cannot be accessed, or you see a “General failure reading drive C” error message	40
You see a “Non-system disk” or “disk error” error message	41
Internet	41
You cannot connect to the Internet	41
You see an “Unable to locate host” message and are unable to browse the Internet	42
Connecting to a Web site takes too long	42
People are sending you e-mail messages, but you have not received any mail	42
Keyboard	43
The keyboard does not work	43
A keyboard character keeps repeating or you see a “keyboard stuck” or “key failure” error message	43
Liquid spilled in the keyboard	43
Memory	43
You see a “Memory error” message	43
You see a “Not enough memory” error message	44
Memory card reader	44
Drive letters for the memory card slots do not appear in the My Computer window	44
Modem (cable or DSL)	44
Modem (dial-up)	44
Your modem does not dial or does not connect	44
You cannot connect to the Internet	46
Your 56K modem does not connect at 56K	46
Your fax communications program only sends and receives faxes at 14,400 bps when you have a 56K modem	46
The modem is not recognized by your computer	47
The modem is noisy when it dials and connects	47
Monitor	47
The screen resolution is not correct	47
The computer is running but there is no picture	47
The color is not uniform	48
The text on the display is dim or difficult to read	48
Mouse	48
The mouse does not work	48
The mouse works erratically	49
Networks	49
You cannot connect to your company network	49
Optical disc drives	49
The computer does not recognize a disc or the CD or DVD drive	49
An audio CD does not produce sound	50
A DVD movie will not play	50
Passwords	51
Your computer does not accept your password	51
Power	51
Your computer will not turn on	51
Printer	52
The printer will not turn on	52
The printer is on but will not print	52
You see a “Printer queue is full” error message	52
You see a “Printer is out of paper” error message	52
Sound	53
You are not getting sound from the speakers	53
Recovering your system	54
To recover your system:	54
Creating recovery discs	55
To create recovery discs:	55
Recovering pre-installed software and drivers	56
To recover your pre-installed software and drivers:	56
Returning your system to its factory condition	57
Recovering from within Windows OS	57
To reinstall Windows OS and all pre-installed software and drivers:	57
Recovering from the hard drive during startup	58
To reinstall Windows OS and all pre-installed software and drivers:	58
Recovering from your recovery discs	58
To reinstall Windows OS and all pre-installed software and drivers:	58
Telephone support	59
Before calling Customer Care	59
Self-help	60

Match case Limit results 1 per page

Appendix A: Regulations and safety notices

device. In order to operate within the limits for compliance with Telecom's

specifications, the associated equipment shall be set to ensure that automatic

calls to different numbers are spaced such that there is not less than 5

seconds between the end of one call attempt and the beginning

of another.

This equipment shall not be set up to make automatic calls to Telecom's 111

Emergency Service.

This device is equipped with pulse dialing while the Telecom standard is

DTMF tone dialing. There is no guarantee that Telecom lines will always

continue to support pulse dialing.

Use of pulse dialing, when this equipment is connected to the same line as

other equipment, may give rise to bell tinkle or noise and may also cause a

false answer condition. Should such problems occur, the user should NOT

contact the telecom Fault Service.

This equipment may not provide for the effective hand-over of a call to

another device connected to the same line.

Under power failure conditions this appliance may not operate. Please ensure

that a separate telephone, not dependent on local power, is available for

emergency use.

Laser compliance statement

The CD or DVD drive used with this computer is a laser product.

The CD or DVD drive's classification label (shown below) is located on the drive.

CLASS 1 LASER PRODUCT

CAUTION: INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE

TO BEAM.

Digital audio output statement

The optical connector contains no laser or light emitting diode (LED) more than

Class I.

Radio device regulatory notice

Note

: Below regulatory information is for models with wireless LAN

and/or Bluetooth only.

General

This product complies with the radio frequency and safety standards of any

country or region in which it has been approved for wireless use. Depending on

configurations, this product may or may not contain wireless radio devices (such as

wireless LAN and/or Bluetooth modules). Below information is for products with

such devices.