1994 Buick LeSabre Owner's Manual - Page 251

0 Use solvent-type cleaners in a well-ventilated area only. If you use them, don't saturatethe stained area. If a ring forms after spot cleaning, clean the entire area immediately or it will set. NOTICE: Be careful with a hair dryer or heat lamp. You could scorch thefabric. 7 Using Foam-Type Cleaner on Fabric 0 0 Vacuum and brush the area to remove any loose dirt. Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. Mix Multi-Purpose. Powdered Cleaner following the directions on the container label. Use suds only and apply with a clean sponge. Don't saturate the material. Don't rub it roughly. As soon as you've cleaned the section, use a sponge to remove the suds. Rinse the section with a clean, wet sponge. Wipe off what's left with a slightly damp paper towel or cloth. Then dry it immediately with a blow dryer or a heat lamp. 0 Wipe with a clean cloth. Using Solvent-Type Cleaner on Fabric First, see if you have to use solvent-type cleaner at all. Some spots and stains will clean off better with just water and mild soap. 0 0 0 0 If you need to use a solvent: 0 0 0 0 Gently scrape excess soil from the trim material with a clean, dull knife or scraper. Use very little cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning should start at the outside of the stain, "feathering" toward the center. Keep changing to a clean section of the cloth. When you clean a stain from fabric, immediately dry the area with an air hose, hair dryer, or heat lamp to help prevent a cleaning ring. (See the previous NOTICE.) 0 0 249