2003 Buick Regal Owner's Manual - Page 72

& : (Remote Alarm) Press this button to activate an alarm. The ignition must be in OFF or ACC for the remote alarm to work. When you press the remote alarm button the headlamps will flash, the horn will sound repeatedly and your interior lamps will turn on, attracting attention. The alarms will continue until one of the following occurs: Programmable Modes Your vehicle can be programmed to one of the following modes. Mode 1: No Verification Mode 2 Horn Chirp only : Mode 3: Headlamps Flash only Mode 4: Horn Chirp and Headlamps Flash Before your vehicle was shipped from the factory, it was programmed to Mode 3. The modeto which your vehicle was programmed may have been changed since it left the factory. To determine which security feedback lock mode yourvehicle is programmed to or to program your vehicle to a different mode, dothe following: 1. Close all doors and turn the ignition key to RUN. 2. Press and hold the power door lock switch in the lock position. 3. While holding the door lock switch in the lock position, press and release the remote keyless entry transmitter LOCK button. This will start the customization mode. While in the customization mode, the feature will sound the number of chimes corresponding to the current lock mode. If you do not wish to change the current mode, you can either exit the programming mode by following the instructions listed here or program the next feature available on your vehicle. 2-5 * You press the remote alarm button on the remote keyless entry transmitter a second time, * the ignition is moved to RUN, or * an alarm period of about two minutes has elapsed. Security Feedback Security feedback provides audible and/or visible feedback confirming that a remote keyless entry lock or unlock command has been received and executed. The ignition must be off for this feature to work. You may select one of four operating modes for reception of a lock command. You may also select one of four operating modes for reception of an unlock command. The selection and programming of the lock and unlock operating modes are independent of each other.