2006 Buick Lucerne Owner's Manual - Page 318

To adjust the vertical aim, do the following: 1. Open the hood. See Hood Release on page 5-11 for more information. 4. At the wall or other flat surface, measure from the ground upward (A) to the recorded distance from Step 3 and mark it. 2. Locate the aim dot on the lens of the low-beam headlamp. 3. Measure the distance from the ground to the aim dot on the low-beam headlamp. Record the distance. 5. Draw or tape a horizontal line (B) on the wall or flat surface the width of the vehicle at the height of the mark in Step 4. Notice: Do not cover a headlamp to improve beam cut-off when aiming. Covering a headlamp may cause excessive heat build-up which may cause damage to the headlamp. 6. Turn on the low-beam headlamps and place a piece of cardboard or equivalent in front of the headlamp not being adjusted. Do not place directly on the headlamp. This allows only the beam of light from the headlamp being adjusted to be seen on the flat surface. 5-50