2007 Buick Rendezvous Owner's Manual - Page 28

Removing the Stowable Seat 1. Remove the convenience center, if it is in the vehicle. See Rear Convenience Center on page 165. 2. Make sure all items are off the stowable seat. 3. From the front of the seat, remove the two nuts, located on the floor on each side of the seat. Notice: Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts and return them to their normal stowed position before folding a rear seat. 4. From behind the bench seat, fold the seatback down. See "Folding the Seatback" previously. 5. Remove the rear nuts located on the floor on each side of the seat. 6. Remove the seat by rocking it slightly toward the rear of the vehicle and then pulling it out the vehicle. This should be done in one motion. 7. Put the nuts back onto the screws so the nuts do not get misplaced. 28 Installing the Stowable Seat {CAUTION: A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After installing the seat, always check to be sure that the safety belts are properly routed and attached, and are not twisted. Do not put the stowable seat in so that it faces rearward. The stowable seat has to be installed before the rear convenience center. See Rear Convenience Center on page 165 for more information.