2013 Buick Verano Owner Manual - Page 221

Driving and Operating SET/− (Set/Coast): Move the thumbwheel down to set a speed and activate cruise control or to make the vehicle decelerate. Setting Cruise Control If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control button off when cruise is not being used. To set a speed: Resuming a Set Speed 9-37 If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed is about 40 km/h (25 mph) or greater, move the thumbwheel up toward RES/+ briefly and then release it. The vehicle returns to the previously set speed and stays there. Increasing Speed While Using Cruise Control If the cruise control system is already activated: . 1 (On/Off): Press the upper or lower portion of the button to turn the cruise control system on or off. An white indicator light will turn on or off in the instrument cluster. * (Cancel): Press to disengage cruise control without erasing the set speed from memory. RES/+ (Resume/Accel): Move the thumbwheel up to resume to a previously set speed or to accelerate. 1. Press 1 to turn cruise control on. 2. Get up to the speed desired. 3. Move the thumbwheel down toward SET/− and release it. 4. Take your foot off the accelerator pedal. When the cruise control has been set to the desired speed, a green cruise control indicator appears on the instrument cluster. When the brakes are applied, the cruise control shuts off. Move the thumbwheel up toward RES/+ and hold it until the vehicle accelerates to the desired speed, then release it. To increase the speed in small amounts, move the thumbwheel up toward RES/+ briefly and then release it. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) faster. .