1999 Cadillac Escalade Owner's Manual - Page 81

yellowblue 4. Remove the RADIO fuse (Fuse 17). This fuse is in the main fuse block, located on the left side of your instrument panel. When the main fuse block is open, the RADIO fuse (Fuse 17) is located in the lower right corner side of the fuse panel. See "Fuses and Circuit Breakers" in the Index. 5. Turn the ignition to ACCESSORY. You can now program your choices. After programming a feature, you can exit the programming mode at anytime. You should hear two chimes to verify that the system is in programming mode. You will also be able to set Lockout Prevention, Keyless Entry Verification, Arming Method and Arming Verification. Programmable Modes Your vehicle can be programmed to one of the following modes. Mode 1: Lockout Prevention Disabled (Doors will lock/unlock when you press the power door lock switch). Mode 2: Lockout Prevention Enabled Your vehicle comes with this feature set in Mode 2. To change the mode: 1. Press the power lock switch on the door. 2. Count the number of chimes you hear. The number of chimes tells you which mode your vehicle is set for. 3. Press the LOCK switch on the door until you hear the number of chimes that correspond to the mode selection you want. The mode you select is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. Lockout Prevention With this feature, the power door locks will not lock when the key is in the ignition in OFF and a door is open. 2-17