2007 Cadillac Escalade ESV Owner's Manual - Page 177

3. Lower the front rollers to the lower guides and pull the system back until the middle set of rollers clear the upper guides. 4. Lower the system until the middle rollers are lined up with lower guides. While holding in the release lever or tab, push the system forward until all three sets of rollers are on the guides. 5. Release the lever or tab and push the system until the locator pin reaches the locator hole. To adjust the system from the lower guide to the upper guide, do the following: 1. Squeeze and hold the release lever, or slide the tab towards the inside of the vehicle, to retract the locator pin. 2. Pull the system back until the middle rollers can be raised and placed into the upper guides. 3. Push the system forward until the front rollers are lined up with the vertical curved guides. 4. Push down on the rear of the system and raise the front rollers up the vertical curved guides. 5. Push the system forward until all three sets of rollers are resting on the guides and release the lever or tab. 6. Push the system forward until the locator pin reaches the locator hole. The cargo management system can be pulled out and used as a table on both the upper and lower guide. To use a table, squeeze the release lever and pull the system towards you. Release the lever and pull the system until the locator pin reaches the next hole. The system will extend out of the vehicle. The liftgate can not be closed in this position. Do not the operate the vehicle with liftgate open. The cargo management system can be removed from the vehicle. This procedure should be completed by two people. While squeezing the release lever, pull the system back until the rollers clear the guides. 177