2008 Cadillac XLR-V Owner's Manual - Page 68

The Canadian immobilizer standard requires Canadian owners to see their dealer/retailer for matching new transmitters when two recognized transmitters are not available. United States owners are permitted to match a new transmitter to their vehicle when a recognized transmitter is not available. The procedure will require three ten minute cycles to complete the matching process. Do the following: 1. The vehicle must be off. 2. Place the new, unrecognized transmitter in the glove box transmitter pocket with the buttons facing to the right. 3. Go to the rear of the vehicle and insert the vehicle key into the key cylinder located on the lower rear fascia on the driver's side of the vehicle. See Trunk on page 2-13 for more information on the key cylinder. 4. Open the trunk. 5. Turn the key five times within five seconds. 6. The DIC message will display OFF-ACC TO LEARN. 7. Press the Acc. button. 8. The DIC will read WAIT 10 MINUTES and will count down to zero, one minute at a time. 9. The DIC will display OFF-ACC TO LEARN again. 10. Press the Acc. button. 11. The DIC will read WAIT 10 MINUTES and will count down to zero, one minute at a time. 12. The DIC will display OFF-ACC TO LEARN again. 13. Press the Acc. button. 14. The DIC will read WAIT 10 MINUTES and will count down to zero, one minute at a time. 15. A beep will sound and the DIC will read READY FOR FOB #1. At this time, all previously known transmitters have been erased. 16. Once the transmitter is recognized and programmed, a beep will sound and the DIC will display READY FOR FOB #2. 2-8