2008 Ford Explorer Sport Trac Quick Reference Guide 2nd Printing
2008 Ford Explorer Sport Trac Manual
2008 Ford Explorer Sport Trac manual content summary:
- 2008 Ford Explorer Sport Trac | Quick Reference Guide 2nd Printing - Page 1
system, refer to your Owner's Guide for detailed information. 10 11 09 12 13 14 THE 2008 SPORT TRAC was engineered with your lifestyle in mind - tough enough to take on what the road ahead gives you, yet sophisticated with new and advanced features. Some of these features you will find to be - 2008 Ford Explorer Sport Trac | Quick Reference Guide 2nd Printing - Page 2
AM/FM1/FM2, tune to a station, press and hold a preset button (1-6) until sound returns. 2008 SPORT TRAC Quick Reference Guide 2008 SPORT TRAC Seating Rear Seats - Folding down the 2nd row 60/40 seats 1. Lower the head restraints by pulling the strap. 2. Locate the handle on the side of the
-
1 -
2
 |
 |
was engineered with your lifestyle in mind – tough enough to take on what the road ahead gives you,
yet sophisticated with new and advanced features.
Some of these features you will find to be intuitive,
while others may be new to you.
Please take a few moments to familiarize yourself with your new
Sport Trac by reading this Quick Reference Guide, which discusses features, specifications and
general information.
For detailed information, refer to your Owner’s Guide.
Use extreme caution when using any device or feature that may take your attention off the road. Your
primary responsibility is the safe operation of the vehicle. Only use non-essential features or devices
when it is safe to do so.
Instrument Panel
01
02
04
05
06
03
07
08
09
10
11
13
12
THE 2008 SPORT TRAC
4. Message Center
The message center displays
features such as trip odometer, compass, distance to
empty, average fuel economy and a language selector.
The message center also provides vehicle system
checks and will notify you of potential vehicle problems
with a display of system warnings.
Optional Message Center
(if equipped)
INFO:
Press to scroll through the following displays:
Odometer, Trip Odometer A or B, Distance to Empty,
Average Fuel Economy, Instantaneous Fuel Economy,
Fuel Used, Trip Elapsed Drive Time and Blank.
RESET:
Press to select and reset functions shown in
the Info (Information) and Setup Menu.
SETUP:
Press to scroll through: System Check,
Units (English/Metric), Language, Autolamp, Autolock,
Autounlock, Park Aid, Compass Zone and Compass
Calibration
5. Turn Signal and Wiper/Washer Control
Move the control down to activate your left turn
signal; move the control up to
activate your right turn signal. To
use your windshield wipers, push
the end of the stalk briefly to cause
a single swipe of the wipers. With
a quick push and hold, the wipers
will swipe three times with washer
fluid. With a long push and hold, the wipers and fluid
will be activated for up to ten seconds. The bars of
varying length are for intermittent wipers. Rotate the
windshield wiper control upward for fast intervals and
downward for slow intervals.
6. Hazard Flasher Control
The hazard flasher is located
on the steering column, just
behind the steering wheel. Press
the flasher control and all front
and rear direction signals will
flash; press the control again to
deactivate the feature.
1. ABS Warning Light
Your
anti-lock braking system (ABS) detects
the onset of wheel lockup during brake
applications and helps prevent wheels
from locking during extreme braking situations.
The ABS warning light will illuminate when you
start the vehicle’s engine. If the light remains
illuminated, continues to flash, or fails to
illuminate, see an authorized dealer’s service
department immediately.
2. Service Engine Soon Light
The Service Engine
Soon indicator light is located in the instrument
cluster and illuminates when the engine is started.
If the light remains illuminated, it may signal a
problem with the On Board Diagnostics System
(OBD-II), refer to your Owner’s Guide for additional
information. If the light is
blinking, engine misfire is occurring which could
damage the vehicle’s catalytic converter. If blinking
occurs, drive in a moderate fashion and have your
vehicle serviced immediately by an authorized dealer.
3. Tire Pressure Monitoring System (TPMS)
When the Tire Pressure Monitoring System (TPMS)
warning light is lit, one or more of your tires is
significantly under-inflated. You should stop and
check the tires as soon as possible, and inflate them
to the proper pressure, as shown on the Safety
Compliance Certification Label (located on the edge
of the driver’s door jamb or B-pillar). Driving on a
significantly under-inflated tire
causes the tire to overheat and
can eventually lead to tire failure.
Note:
Outside temperatures affect
tire pressure; refer to the Owner’s
Guide for additional
tire information.
7. Speed Control
To engage
speed control, press ON, then
momentarily press SET+. To set a
higher speed, press and hold SET
+, then release the control when
you have reached your desired
speed. To set a lower speed,
press and hold SET – until you
have reached your desired speed,
or depress the
brake pedal
and press the
SET + control.
To return to
a previously
set speed,
press RES.
To disengage speed controls,
depress the brake pedal or
press OFF.
8. Headlamp and Panel
Dimmer Control
The headlamp
control is located on the lower
left portion of the instrument
panel. The first clockwise position
controls the parking lamps,
instrument panel lamps, license
plate lamps and tail lamps.
The second clockwise position
controls the headlamps. To
activate the fog lamps, pull the
control out one
position to aid
visibility in fog,
snow or rain.
The autolamps
feature (if
equipped)
automatically
activates/deactivates your
headlamps as necessary. To use
the autolamps feature, rotate
the control counterclockwise; to
deactivate the feature, place the
control in the O (Off) position.
9. Parking Brake Release
Pull the release lever to release
the parking brake. Driving with the
parking brake engaged will cause
the brakes to wear out prematurely
and reduce fuel economy.
10. Four-Wheel Drive
(if equipped) When 4X4
AUTO is selected, power is
automatically provided to all four
wheels. It is used for normal street
and highway driving. 4X4 HIGH is
used for extra traction in slippery
conditions, such as in snow, on
icy roads, or in off-road situations.
It should not be operated on dry
pavement. 4X4 LOW can be
selected to provide extra gearing
to deliver maximum power to all
four wheels. It is intended only for
off-road applications such as deep
sand, steep grades or
pulling heavy objects.
11. AdvanceTrac® with Roll
Stability Control™ (RSC)
Stability Enhancement System
The AdvanceTrac® with RSC
system enhances your vehicle’s
stability during maneuvers that
require all available tire traction, like
in wet/snowy/icy road
conditions and/or when
performing emergency
maneuvers. In an emergency lane
change, the driver may
experience better overall vehicle
traction, and
may have better
control of the
vehicle. The
AdvanceTrac®
with RSC
button allows
the driver to
turn off certain features of the
AdvanceTrac® with RSC system
for speeds below 25 mph (40
km/h). To deactivate, please refer
to the Owner’s Guide for additional
information.
12. Power Adjustable Foot
Pedals
(if equipped)
Press and hold the control to
adjust the
position of the
accelerator and
brake pedal
forward or away
from you, to a
maximum of
three inches of
travel. The accelerator and brake
pedal should only be adjusted
when the vehicle is stopped
and the gearshift lever is in the
P (Park) position.
13. Heated Seats
(if equipped)
The heated seat controls are
located in the lower center of the
instrument panel. To operate the
heated seat
function, push
the control to
activate and
push again to
deactivate.
14. Heated Windshield
(if equipped)
The heated
windshield
control is
located on
the instrument
panel just
under the
climate controls behind the
gear shift lever. To activate the
heated windshield, push the
control. During initial start-up,
the windshield may have a
shimmering appearance. This is
normal operation and will only
last for approximately one minute.
The heated windshield will turn
off automatically after a period
of eight minutes if the outside
temperature is below 40˚F or a
period of four minutes when the
outside temperature is above
40˚F or when the engine is turned
off. To manually turn off the
heated windshield before the
specified time has passed, push
the control switch again. If your
outside mirrors have the
symbol on the glass surface,
your vehicle is equipped with
heated outside mirrors and can
be activated by pressing the
heated windshield switch.
Gearshift/Overdrive (O/D)
Control
Overdrive is the normal
driving position
for the best
fuel economy,
and can be
deactivated by
pressing the
transmission
control switch
on the side of the gearshift lever.
This position allows for all forward
gears except overdrive, provides
engine braking and should be
used when driving conditions
cause excessive shifting from O/D
to other gears, such as city traffic,
hilly terrain and trailer towing.
14
4
Dual Automatic Temperature Control (DATC)
(if equipped)
If your Sport Trac came equipped with another climate system, refer to your Owner’s Guide for detailed information.
1. EXT:
Press the EXT button to display outside
air temperature. Press again to display cabin
temperature settings.
2. Temperature Controls:
To control the
temperature on the driver’s side in single zone
mode, press the driver temperature control; the
climate system’s display indicates the selected
temperature. The passenger side can also be
controlled by selecting the passenger temperature
control, the temperature will appear in the display.
3. AUTO:
Press to select the desired temperature
shown in the display window. The system will
automatically determine the fan speed, the
direction of the airflow, and outside or recirculated
air to heat or cool the vehicle to the
selected temperature.
4. OFF:
Outside air is shut out and the fan will
not operate.
5. Manual Override Controls:
Allows you to
manually determine where airflow is directed. To
return to fully automatic control, press AUTO.
6. DUAL (Single/dual automatic temperature
control):
Allows the driver to have full control
of the cabin temperature settings (single zone)
or allows the passenger to have control of their
individual temperature settings (dual zone control).
Press to turn on dual zone mode; press again to
return to single zone.
7. MAX A/C:
Press to distribute recirculated air
through the instrument panel vents to cool the
vehicle. This recooling of the interior air is more
economical and efficient.
8. Defrost:
Press to clear the windshield of fog
and thin ice.
6
2
7
3
2
The storage compartments are located behind each wheel well in the
pickup box.
1.
Turn the latch counterclockwise to unlock and open the storage
compartment cover.
2.
To close, lower the lid and turn the latch clockwise to lock.
Interior Tiedown Hooks
Your vehicle is equipped with interior tiedown hooks mounted inside the pickup box. Each tiedown hook
can secure loads up to 200 lb. (90 kg). Total pickup box cargo weight is not to exceed overall
vehicle payload.
04
Tonneau Cover
(if equipped)
Your vehicle may be equipped with a lockable tonneau cover. The
tonneau cover key is separate from the ignition key. The tonneau cover
has been designed to maximize fuel economy and should be fully
installed whenever possible.
To open the front panel:
1.
Open the front driver side lock cover and unlock the front panel.
2.
Lift the panel to access items in the pickup box near the cab.
3.
To close, lower the panel down on the pickup box.
To open the rear panel:
1.
Open the lock cover and unlock the rear panel using your ignition key.
2.
Lift the rear panel to access items in the pickup box.
3.
To close, lower the rear panel on the pickup box.
For a more detailed description on proper usage, refer to the Driver Controls chapter of your Owner’s Guide.
Cargo Cage
(if equipped)
Your vehicle may be equipped with a cargo cage designed to extend
the pickup box for larger loads. To extend the cargo cage:
1.
Lower tailgate.
2.
Pull the lever on each side of the cargo cage to release it from the
pickup box.
3.
Flip the cargo cage over on to the tailgate.
4.
Evenly push down on the cargo cage and push the lever in on each
side locking it in place.
To stow the cargo cage, follow steps one through four in reverse order. For more information, refer to the
Driver Controls chapter of your Owner’s Guide.
Cargo Management System & Pickup Box Storage
1
8
The cargo management system consists of a storage compartment
located in the floor of the pickup box. The storage compartment has
have been designed to be a water resistant system. A small amount of
water may drain into the storage compartments with the lid closed.
1.
To open, turn the latch counterclockwise to unlock and lift
the lid.
2.
To close, lower the lid and turn the latch clockwise to lock.
5