1994 GMC Safari Owner's Manual - Page 236

10. Remove the two screws atthe engine cover using a long handled screwdriver. The screws are not supposed to come out of the cover, only from the front of dash. When removing the cover, be careful not to damage the instrument panel or the trim. 11. Grasp the bottom of the cover and slide it backwards. Then, lift it up and out of the vehicle. To Install the Engine Cover: 1. Lift the engine cover into the vehicle andslide it all theway forward. Make sure the rubber seal over the latches. is 2. Install the two screws at the engine cover. Do not tighten the screws all the way. 3. Press down on each of the two latches at the bottom of the cover. Make sure they are secure. 4. Tighten thetwo screws at the engine cover. at 5. Turn the bracket into position and install the bolt. Tighten the nutthe other endof the bracket. studs. Push up on the duct 6. Put the heaterduct over the engine cover gently until it snaps into place. 7. Reconnect the electrical connector for the cigarette lighter. 6-18