1996 GMC Suburban Owner's Manual - Page 80

AUTOMATIC OVERDRIVE (0): position is This for normal driving. If you need more power fur passing. and you're: Going less than about 35 mph (56 km/h), push your accelerator pedal about halfway down. Going about 35 mph (56 km/h) or more, push the accelerator all the way down. If you manually select SECOND (2), the transmission will drive i n second gear. You may use this feature for reducing torque to the rear wheels when you are trying to start your vehicle from a stop on slippery road surfaces. FIRST (1): This position gives you even more power (but lower fuel economy) than SECOND (2). You can use it on very steep hills, or in deep snow or mud. If the You'll shift downto the next gear and have more power. selector lever is put in FIRST ( 1 ) while the vehicle is moving forward, the transmission won't shift into first AUTOMATIC OVERDRIVE (@) can be used when gear until the vehicle is going slowly enough. towing a trailer. You may want to shift the transmission to THIRD (3) or, if necessary, a lower gear selection if the transmission shifts too often when carrying a heavy NOTICE: load, driving on steep hills or for off-road driving. THIRD (3): This position is also used for normal driving, however, it offers more power and lower fuel economy than AUTOMATIC OVERDRIVE (0). SECOND (2): This position gives you more power but lower fuel economy. You can use SECOND (2) on hills. It can help control your speed a s you go down steep mountain roads, but then you would also want to use your brakes off' and on. If your rear wheels can't rotate, don't try to drive. This might happen you were stuck in if very deep sand or mud were up againsta solid or object. You could damage your transmission. Also, if you stop when going uphill, don't hold your vehicle there with only the accelerator pedal. This could overheat and damage the transmission. Use your brakes or shift into PARK(P) to hold your vehicle in position on a hill. 2-16