2004 GMC Yukon Owner's Manual - Page 477

To store the tools, follow these procedures: For Yukon, do the following: 1. Put the tool kit, with the jack tools and gloves, in the tool bag and place in the retaining clip above the jack. 2. Tighten down with the wing nut. 3. Then, assemble wheel chocks and jack together with the wing nut and retaining hook. 4. Position behind the jack storage cover in the left rear side panel and tighten, adjusting clockwise until the jack is secured tight in the mounting bracket. Be sure to position the holes in the base of the jack onto the pin in the mounting bracket. For Yukon XL, do the following: 1. Return the tool kit (jack tools and gloves) to the tool bag. 2. Assemble wheel chocks and jack together with the wing nut and retaining hook. 3. Position under the jack storage tray in the left rear side panel below the wheelbase and tighten, adjusting clockwise until the jack is secured tight in the mounting bracket. Be sure to position the holes in the base of the jack onto the pin in the mounting bracket. 4. Use the retaining clip to fasten the tool kit on the stud in the storage compartment in the rear left trim panel and turn the wing nut clockwise to secure. 5. Return the storage tray. Yukon (Rear Access Panel) A. Tool Kit with Jack Tools B. Retaining Bracket and Wing Nut C. Wing Nut Holding Tire Blocks D. Tire Blocks E. Jack 5-99