2011 GMC Savana 3500 Cargo Owner's Manual - Page 34

2-6 Keys, Doors and Windows 3. If it is the first remote start since the vehicle has been driven, repeat these steps, while the engine is still running, to extend the engine running time by 10 minutes. Remote start can be extended one time. After entering the vehicle during a remote start, insert and turn the key to ON/RUN to drive the vehicle. After a remote start, the engine will automatically shut off after 10 minutes unless a time extension has been done or the key is inserted into the ignition switch and turned to ON/RUN. The maximum number of remote starts between ignition cycles with the key is two. If the remote start procedure is used again before the first 10 minute time frame has ended, the first 10 minutes will immediately expire and the second 10 minute time frame will start. After the engine has been remote started two times, the ignition switch must be turned to ON/RUN and then back to LOCK/OFF using the key before the remote start procedure can be used again. To manually shut off the engine after a remote start: . / (Remote Vehicle Start): This button will be on the RKE transmitter if you have remote start. To start the engine using the remote start feature: 1. Aim the RKE transmitter at the vehicle. 2. Press and release Q on the transmitter, then immediately press and hold / for four seconds or until the turn signal lamps flash. When the engine starts, the parking lamps will turn on and remain on while the engine is running. The doors will be locked. The airbag readiness light will be on during a remote start. It should turn off when the ignition is turned to ON/RUN. See Airbag Readiness Light on page 5‑17 for more information. Aim the RKE transmitter at the vehicle and press / until the parking lamps turn off. Turn on the hazard warning flashers. See Hazard Warning Flashers on page 6‑4. Insert the key into the ignition switch and turn the switch to ON/RUN and then back to LOCK/OFF. . .