2004 Hyundai Accent Owner's Manual - Page 154

DO-IT-YOURSELF MAINTENANCE 6 5 CHANGING THE OIL AND FILTER G040A03A-AAT Oil filler cap 3. Slide underneath the car and loosen the drain plug by turning it counterclockwise with a wrench of the proper size. Be sure that a drain pan is in position to catch the oil as it drains out, then remove the drain plug. ! Oil filter Drain plug ... 7. Refill the crankcase with the recommended engine oil. Refer to the specification in chapter 9 for engine oil capacity. 8. Start the engine and check to be sure no oil is leaking from the drain plug or oil filter. 9. Shut off the engine and recheck the oil level. WARNING: NOTE: Always dispose of used engine oil in an environmentally acceptable manner. It is suggested that it be placed in a sealed container and taken to a service station for reclamation. Do not pour the oil on the ground or put it in with the household trash. Be very careful when draining the engine oil as it may be hot enough to burn you! 4. When the oil has stopped draining, replace the drain plug using a new washer and retighten by turning it clockwise. Oil pan drain plug tightening torque: 3.5 ~ 4.5 kgf.m 5. Remove the oil filter by turning it counterclockwise with a oil filter wrench of the proper size. A certain amount of oil will come out when you remove the filter. So be sure to have your drain pan in place underneath it. 6. Install a new oil filter in accordance with the instructions on the carton or on the filter itself. Do not over-tighten (Tightening torque : 1.2 ~ 1.6 kgf.m). Be sure that the mounting surface on the engine is clean and that the old gasket is removed completely. Lubricate the new gasket on the filter before installation with clean engine oil. F040A02TB The engine oil and filter should be changed at those intervals specified in the maintenance schedule in Section 5. If the car is being driven in severe conditions, more frequent oil and filter changes are required. The procedure for changing the oil and filter is as follows: 1. Park the car on level ground and set the parking brake. Start the engine and let it warm up until the needle on the temperature gauge moves above the lowest mark. Turn the engine off and place the gear selector lever in "P" (automatic) or reverse gear (manual transaxle). 2. Open the hood and remove the engine oil filler cap. ! PROPOSITION 65 WARNING: Used engine oil may cause irritation or cancer of the skin if left in contact with the skin for prolonged periods of time. Used engine oil contains chemicals that have caused cancer in laboratory animals. Always protect your skin by washing your hands thoroughly with soap and warm water as soon as possible after handling used oil.