2005 Hyundai Tiburon Owner's Manual - Page 218

DO-IT-YOURSELF MAINTENANCE 6 29 HEADLIGHT AIMING ADJUSTMENT G290A02GK-AAT Low Beam Vertical aiming G290A03GK High Beam Vertical aiming 1. Keep all tires inflated to the correct pressure. 2. Place the vehicle on level ground and press the front bumper & rear bumper down several times. Place vehicle at a distance of 118 in. (3m) from the test wall. 3. See that the vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and tools). 4. Clean the head light lenses and turn on the headlights. 5. Open the hood. 6. Draw the vertical line (through the center of each headlight beam pattern) and the horizontal line (through the center of each headlight beam pattern) on the aiming screen. And then, draw the parallel line at 0.827 in. (21 mm) under the horizontal line. 7. Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver VERTICAL AIMING. G290B01GK-AAT Adjustment After Headlight Assembly Replacement 0.827 in. (21 mm) Vertical line W Horizontal line "P" H Cut-off line L H Ground line G290B01GK ! G290A04GK WARNING: Horizontal aiming should be adjusted by an authorized Hyundai Dealer. If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming screen as shown in the illustration. Turn on the headlight switch. 1. Adjust headlights so that main axis of light is parallel to center line of the body and is aligned with point "P" shown in the illustration. 2. Dotted lines in the illustration show the center of headlights. Before performing aiming adjustment, make sure of the following.