2006 Hyundai Azera Owner's Manual - Page 183

DRIVING YOUR HYUNDAI 2 3 BEFORE STARTING THE ENGINE C020A01A-AAT TO START THE ENGINE C030A01TG-AAT ! PROPOSITION 65 WARNING: Before you start the engine, you should always: 1. Look around the vehicle to be sure there are no flat tires, puddles of oil, water or other indications of possible trouble. 2. After entering the car, check to be sure the parking brake is engaged. 3. Check that all windows and lights are clean. 4. Check that the interior and exterior mirrors are clean and in position. 5. Check your seat, seatback and headrest to be sure they are in their proper positions. 6. Lock all the doors. 7. Fasten your seat belt and be sure that all other occupants have fastened theirs. 8. Turn off all lights and accessories that are not needed. 9. When you turn the ignition switch to "ON", check that all appropriate warning lights are operating and that you have sufficient fuel. 10. Check the operation of warning lights and all bulbs when key is in the "ON" position. COMBINATION IGNITION SWITCH o Place the shift lever in "P" (park) and depress the brake pedal fully. o To start the engine, insert the ignition key and turn it to the "START" position. Release it as soon as the engine starts. Do not hold the key in the "START" position for more than 15 seconds. Engine exhaust and a wide variety of automobile components and parts, including components found in the interior furnishings in a vehicle, contain or emit chemicals known to the State of California to cause cancer and birth defects and reproductive harm. In addition, certain fluids contained in vehicles and certain products of component wear contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. NOTE: o For safety, the engine will not start if the shift lever is not in "P" or "N" Position. o The ignition key cannot be turned from "ACC" position to "LOCK" position unless the shift lever is in the "P" (Park) position or the negative battery terminal is disconnected from the battery. To remove the key, always confirm that the shift lever is securely positioned in "P" (Park). o For additional information about starting, see page 2-5.