2006 Hyundai Elantra Owner's Manual - Page 218

6 DO-IT-YOURSELFMAINTENANCE 20 CHECKING DRIVE BELTS G190A01A-AAT CHECKING AND REPLACING FUSES G200A03A-AAT Water Pump Pulley 0.2 ~ 0.24 in. (5.1 ~ 6 mm) Replacing a Fusible Link ! CAUTION: Open-Replace Good When replacing a fusible link, never use anything but a new fusible link with the same or lower amperage rating. Never use a piece of wire or a higher-rated fusible link. This could result in serious damage and create a fire hazard. Generator Pulley Crankshaft Pulley HTB186 G200A01E Drive belts should be checked periodically for proper tension and adjusted if necessary. At the same time, belts should be examined for cracks, wear, fraying or other evidence of deterioration and replaced if necessary. Belt routing should also be checked to be sure there is no interference between the belts and other parts of the engine. After a belt is replaced, the new belt should be adjusted again after two or three weeks to eliminate slack resulting from initial stretching after use. A fusible link will melt if the electrical circuits from the battery are ever overloaded, thus preventing damage to the entire wiring harness. (This could be caused by a short in the system drawing too much current.) If this ever happens, have a Hyundai dealer determine the cause, repair the system and replace the fusible link. The fusible links are located in a relay box in the engine compartment for easy inspection.