2007 Hyundai Santa Fe Owner's Manual - Page 23

FEATURES OF YOUR HYUNDAI 1 11 THEFT-ALARM SYSTEM NOTE: The transmitter will not work if any of following occur: - The ignition key is in ignition switch. - You exceed the operating distance limit (10 m). - The battery in the transmitter is weak. - Other vehicles or objects may be blocking the signal. - The weather is extremely cold. - The transmitter is close to a radio transmitter such as a radio station or an airport which can interfere with normal operation of the transmitter. When the transmitter does not work correctly, open and close the door with the ignition key. If you have a problem with the transmitter, contact an authorized Hyundai Dealer. B070A01A-AAT (If installed) This system is designed to provide protection from unauthorized entry into the car. This system is operated in three stages : the first is the "Armed" stage, the second is the "Alarm" stage and the third is the "Disarmed" stage. If triggered, the system provides an audible alarm with blinking of the turn signal lights. B075B01CM-AAT 1) Remove the ignition key from the ignition switch. 2) Make sure that the hood and tail gate are closed and latched. 3) Lock the doors using the transmitter of the keyless entry system or key or central door lock switch. After completion of the steps above, the turn signal lights will blink once and the system will be armed after 30 seconds. The system can also be armed by locking the doors with the key; however, the turn signal lights are not operated. If any door, tailgate or engine hood is opened within 30 seconds after entering the armed stage, the system is disarmed to prevent unnecessary alarm. Armed Stage NOTE: NOTE: Keep the transmitter away from water or any liquid. If the keyless entry system is inoperative due to exposure to water or liquids, it will not be covered by your manufacturer vehicle warranty. HMR If any door, tailgate or engine hood remains open, the system will not be armed. If all doors, tailgate and engine hood are closed, after pressing the "Lock" button on the transmitter, the turn signal lights blink once indicating the system is armed. Park the car and stop the engine. Arm the system as described below.