2007 Hyundai Tucson Owner's Manual - Page 260

DO-IT-YOURSELF MAINTENANCE 6 25 HEADLIGHT AIMING ADJUSTMENT Recommended Fluid Use PSF-3 type fluid G290A03O-AAT NOTE: Do not start the engine when the power steering oil reservoir is empty. G240A01A-AAT POWER STEERING HOSES It is suggested that you check the power steering hose connections for fluid leakage at those intervals specified in the vehicle maintenance schedule in Section 5. The power steering hoses should be replaced if there is severe surface cracking, pulling, scuffing or worn spots. Deterioration of the hose could cause premature failure. G250A01A-AAT Before performing aiming adjustment, make sure of the following. 1. Keep all tires inflated to the correct pressure. 2. Place the vehicle on level ground and press the front bumper & rear bumper down several times. Place vehicle at a distance of 118 in. (3m) from the test wall. 3. See that the vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and tools). Have the driver or equivalent weight placed in driver's seat. 4. Clean the head light lenses and turn on the headlights (Low beam). 5. Open the hood. Vertical aiming Horizontal aiming G290A01JM FOR MORE INFORMATION ABOUT YOUR HYUNDAI If you desire additional information about maintaining and servicing your Hyundai, you may purchase a factory Shop Manual at your Hyundai dealer's parts department. This is the same manual used by dealership technicians and while it is highly technical it can be useful in obtaining a better understanding of your car and how it works. 6. Draw a vertical line (through the center of each headlight beam pattern) and a horizontal line (through the center of each headlight beam pattern) on the aiming screen. And then, draw a parallel line at 0.8 in. (21 mm) under the horizontal line. 7. Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver VERTICAL AIMING.