2009 Hyundai Santa Fe Owner's Manual - Page 242

2 DRIVING YOUR HYUNDAI 32 VEHICLE LOAD LIMIT The power connector (A) that is connected with a controller to operate the trailer lamp and the connector (B) used to judge whether the vehicle lamp operates properly is installed in the left bottom back of the vehicle. You can use it, when needed. C190F01CM-AAT Tire and Loading Information Label Type A Type C ! CAUTION: I030A03CM I030A01CM o When using the trailer pack, open the cap(C) and then connect it to the connector. After using the connector, disconnect it and always put the cap(C) back on the corresponding connector. If the cap is not replaced, foreign elements such as dust or liquid may damage the vehicle. o You must use a separate controller to use the power connector(A) to operate the trailer lamp. o The connector B is only for the vehicle lamp. Therefore, do not use the connector B to operate the trailer lamp. It may blow out the fuse and damage the vehicle. o While the connector is connected to the trailer, make sure the connector wire does not go near the muffler. The heat from the muffler may damage the wire. Type D Type B I030A04CM I030A02CM