1996 Toyota Camry Owners Manual - Page 106

The radio has two FM selections, "FM1" and "FM2". You can preset any desired six stations in each selection. When you preset an FM station, check which selection you have used. 2. Tune in the desired station. (See "(b) Selecting a station".) 3. Push one of the station selector buttons and hold it until a beep is heard. This sets the station to the button and the button number will appear on the display. To change the preset station to a different one, follow the same procedure. The preset station will be cancelled when the power source is severed (battery disconnected, burnt fuse, etc.). (d) Adjusting the tone Automatic tone adjustment Push the "EQ" button repeatedly until the desired frequency response pattern appears on the display. This function automatically controls the tone in accordance with the selected pattern. To change the preset mode, adjust the manual tone control knobs as you like. (See the following "Manual tone adjustment".) To memorize the setting you have selected, push the "EQ" button for 2 seconds until a beep is heard. To cancel the memory, push the "EQ" button for 10 seconds until the second beep is heard. To cancel all the memory which you have set, push the "EQ" button for 20 seconds until the third beep is heard. Manual tone adjustment Before using the tone controls, push the "EQ" button repeatedly until your desired response pattern appears on the display. To adjust a low-pitched tone, push the "BASS" knob (if pushed in) and turn it. At the time, the "BASS" display will change. To adjust a middle-pitched tone, push the "MID BAL" knob (if pushed in) and turn it. At the time, the "MID" display will change. To adjust a high-pitched tone, push the "TREB FADE" knob (if pushed in) and turn it. At the time, the "TREB" display will change. (e) Adjusting the sound balance To balance the sound between the right and left speakers, push the "MID BAL" knob (if pushed in), pull it fully out and turn it. To balance the sound between the front and rear speakers, push the "TREB FADE" knob (if pushed in), pull it fully out and turn it. (f) Listening to the cassette tape 1. Put the cassette into the slot, with the tape side to the right and lightly push it in. The tape player will grab the cassette and slide it into place to play it. If the radio or Compact Disc player is on when inserting the cassette, it will automatically turn off. If the cassette is already in the slot, push the "TAPE" button. At this time, "PLAY" will appear on the display. The tape player can also be turned on by pushing the "PWR VOL" knob if the tape player was playing when the system was turned off by pushing the knob. When a metal or chrome equivalent tape is inserted, the player will automatically adapt to it and "MTL" will appear on the display. 2. If using a tape recorded with DolbyR NR*, push the button by the double-D symbol to select the Dolby B NR or Dolby C NR mode. The display will indicate which Dolby noise reduction system is operating. The Dolby B NR mode reduces tape noise by about 10 dB. The Dolby C NR mode reduces tape noise by another 10 dB, or about 20 dB total. For best sound reproduction, select the same NR mode that was used to record the tape. 100