1996 Toyota Camry Owners Manual - Page 116
1996 Toyota Camry Manual
Page 116 highlights
For detailed information on air flow control including other settings, see "(f) Air flow selection". 4. Turn the fan speed control knob anywhere except the "OFF" position. 5. Press in the air conditioning on-off button. (d) Ventilation 1. Turn the temperature control knob at the LOW position. 2. Move the air intake control lever to the OUTSIDE AIR position. 3. Turn the air flow control knob to the FACE position. For detailed information on air flow control including other settings, see "(f) Air flow selection". 4. Turn the fan speed control knob anywhere except the "OFF" position. 5. Leave the air conditioning on-off button in the OFF position. (e) Windshield defogging and defrosting To remove interior fog on the windshield: 1. Turn the temperature control knob to any position. 2. Move the air intake control lever to the OUTSIDE AIR position. 3. Turn the air flow control knob to the WINDSHIELD position. For detailed information on air flow control, see "(f) Air flow selection". 4. Turn the fan speed control knob anywhere except the "OFF" position. 5. Press in the air conditioning on-off button. To remove frost or exterior fog on the windshield: 1. Turn the temperature control knob to the HIGH position. 2. Move the air intake control lever to the OUTSIDE AIR position. 3. Turn the air flow control knob to the WINDSHIELD position. For detailed information on air flow control, see "(f) Air flow selection". 4. Turn the fan speed control knob to the "HI" position. 5. Leave the air conditioning on-off button in the OFF position. (f) Air flow selection FACE position-This position directs the air flow to face level. BI-LEVEL position-This position directs the air flow to face level and the floor. Except in ventilation, the air to the floor is slightly warmer than that to face level. FLOOR position-This position directs air flow mostly to the floor. FLOOR/WINDSHIELD position - This position directs the air flow to the windshield as well as the floor. WINDSHIELD position-This position directs air flow mostly to the windshield and front side windows. Do not use the WINDSHIELD position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, blocking your vision. (g) Operating tips S Be sure the air inlet grilles in front of the windshield are not blocked by leaves or other obstructions. S If air flow control is not satisfactory, check the dashboard vents. (See "Side vents" or "Lower vent" after "Heater controls".) 110