1996 Toyota Camry Owners Manual - Page 121

For detailed information on air flow control including other settings, see "(f) Air flow selection". 4. Press in any fan speed control button except the "OFF" button. 5. Press in the air conditioning on-off button. (d) Ventilation 1. Turn the temperature control knob at the LOW position. 2. Set to the OUTSIDE AIR mode of the air intake control buttons. 3. Press in the FACE button of the air flow control buttons. For detailed information on air flow control including other settings, see "(f) Air flow selection". 4. Turn the fan speed control knob anywhere except the "OFF" position. 5. Leave the air conditioning on-off button in the OFF position. (e) Windshield defogging and defrosting To remove interior fog on the windshield: 1. Turn the temperature control knob to any position. 2. Set to the OUTSIDE AIR mode of the air intake control buttons. 3. Press in the WINDSHIELD button of the air flow control buttons. For detailed information on air flow control, see "(f) Air flow selection". 4. Turn the fan speed control knob anywhere except the "OFF" position. 5. Press in the air conditioning on-off button. To remove frost or exterior fog on the windshield: 1. Turn the temperature control knob to the HIGH position. 2. Set to the OUTSIDE AIR mode of the air intake control buttons. 3. Press in the WINDSHIELD button of the air flow control buttons. For detailed information on air flow control, see "(f) Air flow selection". 4. Turn the fan speed control knob to the "HI" position. 5. Leave the air conditioning on-off button in the OFF position. (f) Air flow selection FACE button-This button directs the air flow to face level. BI-LEVEL button-This button directs the air flow to face level and the floor. Except in ventilation, the air to the floor is slightly warmer than that to face level. FLOOR button-This button directs air flow mostly to the floor. FLOOR/WINDSHIELD button-This button directs air flow to the windshield as well as the floor. WINDSHIELD button-This button directs air flow mostly to the windshield and front side windows. Do not use the WINDSHIELD button during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, blocking your vision. (g) Operating tips S Be sure the air inlet grilles in front of the windshield are not blocked by leaves or other obstructions. S If air flow control is not satisfactory, check the dashboard vents. (See "Side vents" or "Lower vent" after "Heater controls".) S To help cool down the interior after parking in the hot sun, drive for the first few minutes with the windows open. After the excess heat has blown away, close the windows. 115