1996 Toyota Camry Owners Manual - Page 157

S The gas normally produced by a battery will explode if a flame or spark is brought near. Use only standardized jumper cables and do not smoke or light a match while jump starting. NOTICE The battery used for boosting must be 12 V. Do not jump start unless you are sure that the booster battery is correct. JUMP STARTING PROCEDURE 1. If the booster battery is installed in another vehicle, make sure the vehicles are not touching. Turn off all unnecessary lights and accessories. 2. If required, remove all the vent plugs from the booster and discharged batteries. Lay a cloth over the open vents on the batteries. (This helps reduce the explosion hazard, personal injuries and burns.) 3. If the engine in the vehicle with the booster battery is not running, start it and let it run for a few minutes. During jump starting, run the engine at about 2000 rpm with the accelerator pedal lightly depressed. 4. Connect the jumper cables in the exact order shown in the illustration: positive terminal ("+" mark)-to-positive terminal ("+" mark), and negative terminal ("-" mark)-to-engine or body ground. Note that you first connect the positive cable to the discharged battery and then to the booster battery. Next, connect the negative cable to the booster battery and then to a solid, stationary, unpainted, metallic point (e.g. 5S-FE engine-engine hanging hook, 1MZ-FE engine-cylinder head) away from the battery. Do not connect it to or near any part that moves when the engine is cranked. 8. If removed, replace all the battery vent plugs. If the cause of your battery discharging is not apparent (for example, lights left on), you should have it checked. ! CAUTION When making the connections, do not lean over the battery or accidentally let the jumper cables or clamps touch anything except the correct battery terminals or the ground. 5. Start your engine in the normal way. After starting, run it at about 2000 rpm for several minutes with the accelerator pedal lightly depressed. 6. Carefully disconnect the cables in the exact reverse order: the negative cable and then the positive cable. 7. Carefully dispose of the battery cover cloths-they may now contain sulfuric acid. 151