1996 Toyota Camry Owners Manual - Page 194

Checking brake fluid If the level is low, add SAE J1703 or FMVSS No. 116 DOT 3 brake fluid to the brake reservoir. Remove and replace the reservoir cover by hand. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. Checking power steering fluid ! CAUTION To check the fluid level, simply look at the see-through reservoir. The level should be between the "MAX" and "MIN" lines on the tank. It is normal for the brake fluid level to go down slightly as the brake pads wear. So be sure to keep the reservoir filled. If the reservoir needs frequent refilling, it may indicate a serious mechanical problem. Take care when filling the reservoir because brake fluid can harm your eyes and damage painted surfaces. If fluid gets in your eyes, flush your eyes with clean water. Check the fluid level through the reservoir. If necessary, add automatic transmission fluid DEXRON® -II or -III. If the vehicle has been driven around 80 km/h (50 mph) for 20 minutes (a little more in frigid temperatures), the fluid is hot 60_C80_C (140_F175_F). You may also check the level when the fluid is cold (about room temperature, 10_C30_C or 50_F85_F) if the engine has not been run for about five hours. NOTICE If you spill some of the fluid, be sure to wash it off with water to prevent it from damaging the parts or paint. 188