1996 Toyota Celica Owners Manual - Page 41

Coupe and liftback only-Your vehicle has anchors for securing the top strap of a child restraint system. The anchor nuts are welded beneath the sheet metal to permit installation of an anchor bracket for a child restraint system. To install an anchor bracket, use an 8 mm X 30 mm X 1.25 mm coarse thread metric bolt and 15 mm (0.6 in.) spacer. Note that the bolts accompanying many child restraint systems are not metric. You can damage the anchor nuts on our vehicle if you force bolts with different thread into the anchor nuts. For instructions about how to install the anchor bracket, see "(B) TOP STRAP ANCHORS AND LOCATIONS". If your child restraint system does not provide any of the necessary parts, you can purchase the following items from your Toyota dealer. * CRS installation kit (Part No. 04731-22012) -contains 1 bolt, 3 types of spacers and 1 locking clip. * Bolt (Part No. 91511-60830) (A) INSTALLATION ON REAR SEAT When installing a rear-facing child restraint system, follow the same procedure as when installing a forward-facing child restraint system. 1. Fasten the lap and shoulder belt over the child restraint system following the instructions provided by its manufacturer. Keep the lap portion of the belt tight. ! CAUTION S After inserting the tab, make sure the tab and buckle are locked. S Do not insert coins, clips, etc. in the buckle as this may prevent you from properly latching the tab and buckle. S If the seat belt does not function normally, immediately contact your Toyota dealer. ! CAUTION Do not use a rear-facing child restraint system in the rear seat if it interferes with the lock mechanism of the front seats. This can cause severe injury to the child and front passenger in case of sudden braking or a collision. 34