1996 Toyota Corolla Owners Manual - Page 140

-Changing wheels -Reinstalling wheel nuts 7. Remove the wheel nuts and change tires. Lift the flat tire straight off and put it aside. Roll the spare wheel into position and align the holes in the wheel with the bolts. Then lift up the wheel and get at least the top bolt started through its hole. Wiggle the tire and press it back over the other bolts. On aluminum wheels, put the wheel ornament off from the dismounted wheel by tapping on the reverse side with the wheel nut wrench. This prevents the ornament from being damaged. Before putting on wheels, remove any corrosion on the mounting surfaces with a wire brush or such. Installation of wheels without good metal-to-metal contact at the mounting surface can cause wheel nuts to loosen and eventually cause a wheel to come off while driving. Therefore after the first 1600 km (1000 miles), check to see that the wheel nuts are tight. 8. Reinstall all the wheel nuts finger tight. Reinstall the wheel nuts (tapered end inward) and tighten them as much as you can by hand. Press back on the tire and see if you can tighten them more. 134