1996 Toyota Corolla Owners Manual - Page 56
1996 Toyota Corolla Manual
Page 56 highlights
(C)TOP STRAP ANCHORS AND LOCATIONS Sedan-On the filler panel behind the rear seat With filler panel trim- a. Using the illustration as a guide, run your fingers across the trim of the filler panel itself to locate the position of the holes underneath. b. Make a hole in the covering directly above the hole in the filler panel. c. Insert a 10 mm (0.4 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5-24.7 N⋅m (1.68-2.52 kgf⋅m, 12.2-18.2 ft⋅lbf). Without filler panel trim- a. Remove the cap on the filler panel you wish to use. b. Insert a 10 mm (0.4 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5-24.7 N⋅m (1.68-2.52 kgf⋅m, 12.2-18.2 ft⋅lbf). To comply with Canada Motor Vehicle Safety Standards, vehicles sold in Canada are provided with a bracket set in the glovebox, designed for use with any of the 3 anchor locations shown in the illustration. Wagon -On the rear cargo floor Center anchor- a. Roll up the covering on the rear cargo floor. The center anchor hole is plugged. Cut out the rear deck trim along the dotted line. b. Insert a 10 mm (0.4 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5-24.7 N⋅m (1.68-2.52 kgf⋅m, 12.2-18.2 ft⋅lbf). c. Cut a small hole in the floor covering to allow the anchor bracket to come through and then reinstall the floor covering. 50