1996 Toyota RAV4 Owners Manual - Page 78

1 2 3 4 5 6 (Preset buttons) These buttons are used to preset and tune in radio stations. To preset a station to a button: Tune in the desired station (see "TUNE"). Push and hold down the button until you hear a beep-this will set the station to the button. The button number will appear on the display. To tune in to a preset station: Push the button for the station you want. The button number and station frequency will appear on the display. These systems can store one AM and one FM station for each button. The preset station memory will be canceled out if the power source is interrupted (battery disconnected or fuse blown). AM⋅FM Push "AM⋅FM" to switch between the AM and FM bands. "AM" or "FM" will appear on the display. If the audio system is off, you can turn on the radio by pushing "AM⋅FM". BAL (Balance) This knob lets you adjust the balance between the right and left speakers. Push"BAL/FADE" so that it pops out of its retracted position. Turn the knob to adjust the balance. Push the knob back into its retracted position. BASS This knob lets you adjust the bass level. Push "BASS/TREB" so that it pops out of its retracted position. Turn the knob to adjust the bass. Push the knob back into its retracted position. FADE This knob lets you adjust the balance between the front and rear speakers. Push "BAL/FADE" so that it pops out of its retracted position. Pull out the knob. Turn the knob to adjust the front/rear balance. Push the knob back into its retracted position. PWR⋅VOL (Power⋅Volume) Push "PWR⋅VOL" to turn the audio system on and off. Turn the "PWR⋅VOL" knob to adjust the volume. SCAN When you push "SCAN", the radio finds the next station up the station band, plays it for 5 seconds, and then scans again. To select a station, push "SCAN" a second time. ST (Stereo reception) display Your radio automatically changes to stereo reception when a stereo broadcast is received. "ST" appears on the display. If the signal becomes weak, the radio reduces the amount of channel separation to prevent the weak signal from creating noise. If the signal becomes extremely weak, the radio switches from stereo to mono reception. 72