1996 Toyota RAV4 Owners Manual - Page 81

1 2 3 4 5 6 (Preset buttons) These buttons are used to preset and tune in radio stations. To preset a station to a button: Tune in the desired station (see "TUNE"). Push and hold down the button until you hear a beep-this will set the station to the button. The button number will appear on the display. To tune in to a preset station: Push the button for the station you want. The button number and station frequency will appear on the display. These systems can store one AM and one FM station for each button. The preset station memory will be canceled out if the power source is interrupted (battery disconnected or fuse blown). (Eject button) Push this button to eject a cassette. After you turn the ignition to "LOCK", you will be able to eject a cassette but you will not be able to reinsert it. AM⋅FM Push "AM⋅FM" to switch between the AM and FM bands. "AM" or "FM" will appear on the display. If the audio system is off, you can turn on the radio by pushing "AM⋅FM". Also, push the "AM⋅FM" button to switch from cassette operation to radio operation. BAL (Balance) This knob lets you adjust the balance between the right and left speakers. Pull out "PWR/VOL/BAL". Turn the knob to adjust the balance. Push the knob back into its normal position. BASS This knob lets you adjust the bass level. Push "BASS/TREB" so that it pops out of its retracted position. Turn the knob to adjust the bass. Push the knob back into its retracted position. Dolby ® NR* If you are listening to a tape that was recorded with Dolby® Noise Reduction, push the button marked with the double-D symbol. The double-D symbol will appear on the display. Push the button again to turn off Dolby® NR. The Dolby NR mode reduces tape noise by about 10 dB. For best sound reproduction, play your tapes with this button on or off according to the mode used for recording the tape. *: Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. are trademarks "DOLBY" and the double D symbol of Dolby Laboratories Licensing Corporation. FADE Move the "FADE" ring around "PWR/ VOL" to adjust the front/rear balance. MTL (Metal) display If a metal or chrome equivalent cassette tape is put in the cassette player, the player will automatically adapt to it and "MTL" will appear on the display. PROG (Program) Push "PROG" to select the other side of a cassette tape. The display indicates which side is currently selected ( "∧" indicates top side, "∨" indicates bottom side). Auto-reverse feature-After the cassette player reaches the end of a tape side, it automatically reverses and begins to play the other side. This is true whether the cassette was playing or fast forwarding. PWR/VOL (Power/Volume) Push "PWR/VOL" to turn the audio system on and off. Turn the "PWR/VOL" knob to adjust the volume. Pull out and then turn "PWR/VOL" to adjust the balance between the right and left speakers. Move the "FADE" ring around "PWR/VOL" to adjust the front/rear balance. 75