1996 Toyota Supra Owners Manual - Page 175

Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the ignition switch and light switch are off. Use bulbs with the wattage ratings given in the table. ! CAUTION Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. To check the headlight aim, check the vertical and horizontal gauges. 1. Look at the beam angle gauge (vertical movement). The bubble of the gauge should not deviate from the center of the gauge by more than two marks on either side of the gauge. 2. Look at the beam angle gauge (horizontal movement). The "0" mark should not deviate by more than one mark on either side of the gauge. If the error is over the value specified above, take the vehicle to your Toyota dealer to adjust the headlight aim. NOTICE Only use a bulb of the listed type. Light Bulbs Headlights (low beam) Headlights (high beam) Front fog lights Parking lights Front turn signal lights Front side marker lights Rear side marker lights Rear turn signal lights Bulb No. 9006 9005 - - 1156 194 194 1156 W 55 65 55 5 27 3.8 3.8 27 Type A B C E D E E D 169