1996 Toyota Supra Owners Manual - Page 19

Reactivating the alarm Once set, the system automatically resets the alarm each time all the side doors, back door and hood are closed after the alarm stops. The alarm will be activated again under the following conditions: S If any of the side doors, back door or hood is opened S If the battery terminal is disconnected and then reconnected Stopping the alarm Turn the ignition key from the "LOCK" to "ACC" position . The alarm will be stopped with the starter circuit cut kept on. Stopping the alarm in this manner will keep the alarm from being reactivated when any of the side doors, back door or hood is opened. Interrupting the setting When the system set, the back door can be opened by using the key without setting off the system. While the back door is open, the setting is interrupted and the side doors and hood may be opened in addition. However, when the battery terminal is disconnected and then reconnected, the system is activated. Close and lock the side doors and hood, and the system will automatically be reset after two seconds when the back door is closed with the key removed. CANCELLING THE SYSTEM Unlock either side door with the key. This cancels the system completely and the starter circuit cut will be cancelled at once. INDICATOR LIGHT The indicator light gives the following three indications. FLASHING-The system is set. You need the key to open the side doors, back door and hood. ON-The system will automatically be set when the time comes. The side doors, back door and hood may be opened without a key. OFF-The system is inactive. You may open any of the side doors, back door and hood. TESTING THE SYSTEM 1. Open the windows 2. Set the system as described above. The side doors should be locked with the key. Be sure to wait until the indicator light starts flashing. 3. Unlock either side door from the inside. The system should activate the alarm. 4. Cancel the system by unlocking either side door with the key. 5. Repeat this operation for the other side door, back door and hood. When testing on the hood, also check that the system is activated when the battery terminal is disconnected and then reconnected. If the system does not work properly, have it checked by your Toyota dealer. 14