1996 Toyota T100 Owners Manual - Page 74

(a) Listening to the radio 1. Push the "PWR⋅VOL" knob to turn the radio on. 2. Turn the "PWR⋅VOL" knob to adjust the volume. 3. Tune in the desired station. (See "(b) Selecting a station" and "(c) Presetting a station".) The radio will change automatically to stereo reception when an FM stereo broadcast is being received. At this time, "ST" will appear on the display. When the receiving signal gets weak, the channel separation will automatically be reduced for the lowest noise. If the signal becomes extremely weak, the radio will switch over to monaural reception. 4. Adjust the tone and sound balance. (See "(d) Adjusting the tone" and "(e) Adjusting the sound balance".) 5. To turn the radio off, push the "PWR⋅VOL" knob once again. (b) Selecting a station 1. Push the "AM⋅FM" button to select either an AM or FM broadcast. "AM" or "FM" will appear on the display. 2. Tune in the desired station using one of the following methods. The frequency will appear on the display. Preset tuning: Use for tuning-in to a desired preset station. Push the station selector button which has been preset to the desired station. The radio will tune in to the station and the button number will appear on the display. (See "(c) Presetting a station".) Seek tuning: Use for automatic station search and stop. Push either side of the "TUNE" button and hold it until a beep is heard. The radio will begin seeking up or down for a station of the nearest frequency and will stop on reception. Each time you push the button, stations will be seeked out one after another. Manual tuning Push either side of the "TUNE" button for less than 0.5 second. Each time you push the button, the radio will step up or down to another frequency where stations could exist. (c) Presetting a station 1. Tune in the desired station. (See "(b) Selecting a station".) 2. Push one of the station selector buttons and hold it until a beep is heard. This sets the station to the button and the button number will appear on the display. Each button can store one AM station and one FM station. To change the preset station to a different one, follow the same procedure. The preset station will be cancelled when the power source is severed (battery disconnected, burnt fuse, etc.). (d) Adjusting the tone Turn the "TONE" knob. (e) Adjusting the sound balance Turn the "BAL" knob. 68