1996 Toyota T100 Owners Manual - Page 79

(a) Listening to the radio 1. Push the "AM⋅FM" button to turn the radio on and select either an AM or FM broadcast. "AM" or"FM" will appear on the display. The radio can also be turned on by pushing the "PWR⋅VOL" knob if the radio was on when the system was turned off. 2. Turn the "PWR⋅VOL" knob to adjust the volume. 3. Tune in the desired station. (See "(b) Selecting a station" and "(c) Presetting a station".) The radio will change automatically to stereo reception when an FM stereo broadcast is being received. At the same time, "ST" will appear on the display. When the receiving signal gets weak, the channel separation will automatically be reduced for the lowest noise. If the signal becomes extremely weak, the radio will switch over to monaural reception. 4. Adjust the tone and sound balance. (See "(d) Adjusting the tone" and "(e) Adjusting the sound balance".) 5. To turn the radio off, push the "PWR⋅VOL" knob. (b) Selecting a station Tune in the desired station using one of the following methods. The frequency will appear on the display. Preset tuning: Use for tuning-in to a desired preset station. (See "(c) Presetting a station".) Push the station selector button which has been preset to the desired station. The radio will tune in to the station and the button number will appear on the display. Seek tuning: Use for automatic station search and stop. Push the "TUNE (REW FF)" button on either side and hold it until a beep is heard. The radio will begin seeking up or down for a station of the nearest frequency and will stop on reception. Each time you push the button, stations will be seeked out one after another. Scan tuning: Use for station-to-station scanning. Scanning for all frequencies-Push the "SCAN" button and hold it until a beep is heard. With "SCAN" on the display, the radio will automatically seek out a station of a higher frequency, hold it for 5 seconds and scan to the next. To continue listening to the broadcast of your choice, simply push the "SCAN" button once again. If the radio scans over all frequencies without stop because the signals are too weak or just because you leave it going, the radio will begin scanning again with sensitivity boosted for searching out weak stations. Scanning for preset stations-Push the "SCAN" button within 2 seconds. With "SCAN" on the display, the radio will automatically seek out a preset station, hold it for 5 seconds and scan to the next. To continue listening to the station of your choice, simply push the "SCAN" button once again. Manual tuning Push either side of the "TUNE (REW FF)" button for less than 0.5 second. Each time you push the button, the radio will step up or down to another frequency where stations could exist. (c) Presetting a station 1. Tune in the desired station. (See "(b) Selecting a station". 2. Push one of the station selector buttons and hold it until a beep is heard. This sets the station to the button and the button number will appear on the display. Each button can store one AM station and one FM station. To change the preset station to a different one, follow the same procedure. 73