1998 Toyota Camry Owners Manual - Page 72

Bolt Spacer Anchor bracket 345 mm (13.6 in.) To comply with Canada Motor Vehicle Safety Standards, vehicles sold in Canada are provided with a bracket set in the glovebox, designed for use with any of the 3 anchor locations shown in the illustration. If your child restraint system does not provide any of the necessary parts, ask your Toyota dealer. (See "-Child restraint system".) 100 mm (4.0 in.) 185 mm (7.3 in.) On the filler panel behind the rear seat Center anchor- a. Using the illustration as a guide, run your fingers across the trim of the filler panel itself to locate the position of the holes underneath. b. Make a hole in the covering directly above the hole in the filler panel. c. Insert a 15 mm (0.6 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5-24.7 N⋅ m (1.68-2.52 kgf⋅ m, 12.2-18.2 ft⋅ lbf). Outside anchors- a. Should you select to use the outer anchor positions, please contact your Toyota dealer for proper modifications to the filler panel. b. After modifications have been made to the filler panel, insert a 15 mm (0.6 in.) spacer and tighten down the anchor bracket for your child restraint system with a bolt. Torque the bolt to 16.5-24.7 N⋅ m (1.68-2.52 kgf⋅ m, 12.2-18.2 ft⋅ lbf). c. Securely latch the hook of the top strap onto the anchor bracket and make sure the hook does not make contact with the filler panel. 72