1998 Toyota RAV4 Owners Manual - Page 181

Replacing light bulbs- CAUTION To prevent burning yourself, do not check the washer fluid level when the motor is hot. The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the motor switch and light switch are off. Use bulbs with the wattage ratings given in the table. Light bulbs Headlight inner outer Parking and front turn signal lights Front side marker lights Rear side marker lights Rear turn signal lights Stop and tail lights Back- up lights License plate light High mounted stop light Interior light Personal light (with moon roof) Personal lights (without moon roof) Bulb No. HB3 HB4 1157NA 217 194 7740 7743 7730 - 921 - - - W Type 60 51 27/8 5 3.8 21 21/5 21 5 18 8 10 8 B A C D D D D D D D E C C CAUTION NOTICE z After checking the washer fluid level, make sure the dipstick is securely reinserted. If it is loose, fluid may leak from the reservoir. z Do not check the washer fluid level or add washer fluid when the motor is running or when it is hot. If the fluid is spilled over the hot traction motor, a fire could result. z If you have added washer fluid until it is close to the top of the opening for adding fluid, do not pull out the dipstick. Otherwise, the fluid will overflow. z Do not use engine antifreeze or any other substitute because it may damage your vehicle's paint. Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. NOTICE Only use a bulb of the listed type. A: B: C: D: E: HB4 halogen bulbs HB3 halogen bulbs Single end bulbs Wedge base bulbs Double end bulbs 173