1999 Toyota 4Runner Owners Manual - Page 101

4RUNNER ( ) Vehicles with cruise control-When the cruise control is being used, even if you downshift the transmission by turning off the overdrive switch, engine braking is not applied because the cruise control is not cancelled. For ways to decrease the vehicle speed, see "Cruise control i n this chapter. NOTICE z Be careful not to overrev the engine. Watch the tachometer to keep engine rpm from going into the red zone. The approximate maximum allowable speed for each position is given above for your reference: z Do not continue hill climbing or hard towing for a long time in the "2" or "L" position. This may cause severe automatic transmission damage from overheating. To prevent such damage, "D" position should be used in hill climbing or hard towing. (d) Backing up 1. Bring the vehicle to a complete stop. 2. With the brake pedal held down with your foot, shift the selector lever to the "R" position. CAUTION Be careful when downshifting on a slippery surface. Abrupt shifting could cause the vehicle to spin or skid. (c) Using the "2" and "L", positions The "2" and "L" positions are used for strong engine braking as described previously. With the selector lever in "2" or "L", you can start the vehicle in motion as with the lever in "D". With the selector lever in "2", the vehicle will start in the first gear and automatically shift to the second gear. With the selector lever in "L", the transmission is engaged in the first gear. Front drive control lever in "H2" or "H4" 3RZ- FE engine "2" ...111km/h (68 mph) "L" ...60km/h (37 mph) 5VZ- FE engine "2" ...118km/h (73 mph) "L" ...64km/h (40 mph) Front drive control lever in "L4" 3RZ- FE engine "2" ..."L" ...5VZ- FE engine "2" ..."L" ...43km/h (26 mph) 23km/h (14 mph) 46km/h (28 mph) 25km/h (15 mph) NOTICE Never shift into reverse while the vehicle is moving. (e) Parking 1. Bring the vehicle to a complete stop. 2. Pull the parking brake lever fully to securely apply the parking brake. 3. With the brake pedal pressed down, shift the selector lever to the "P" position. 101