1999 Toyota Sienna Owners Manual - Page 23

name. SIENNA (45403U) Wireless remote control 1. Be sure to turn off the power sliding door system by pushing in the "PWR DOOR OFF" switch. 2. Disconnect the battery for 1 minute and then reconnect it. 3. Close the sliding door by hand. (Step 3 can be performed before step 2.) 4. Turn on the power sliding door system by pushing out the "PWR DOOR OFF" switch. 5. Wait 5 seconds. 6. Open the sliding door by using one of the "PWR DOOR" switches or wireless remote control transmitter. 7. Wait 3 seconds after the sliding door stops at the fully −opened position. 8. Close the sliding door by using one of the "PWR DOOR" switches or wireless remote control transmitter. 9. Wait 3 seconds after the sliding door stops at the fully −closed position. 10. Repeat the steps from 6 to 9. If the power sliding door system does not operate properly after the above procedure, there may be a problem in the system. Contact your Toyota dealer. Locking operation The wireless remote control system allows you to lock or unlock all the doors from a distance within approximately 1 m (3 ft.) of the vehicle. On some models, the system also allows you to activate the theft deterrent system from the same distance. LOCKING DOORS AND UNLOCKING THE To lock and unlock all the doors, push the switches of the transmitter slowly and securely. To lock: Push the "LOCK" switch. All the doors are locked simultaneously. At this time, parking lights, side marker lights and tail lights flash. Check to see that the doors are securely locked. If any of the doors is not securely closed, or if the key is in the ignition switch, locking cannot be performed by the "LOCK" switch. To unlock: Push the "UNLOCK" switch once to unlock the driver's door alone. Pushing the switch twice within 3 seconds unlocks all the doors simultaneously. At this time, parking lights, side marker lights and tail lights flash twice. Unlocking operation 23