1999 Toyota Sienna Owners Manual - Page 33

name. SIENNA (45403U) As the doors are locked, the system will give you a preparation time of 30 seconds before the setting, during which the front, sliding or back doors and hood may be opened. Be careful not to unlock any door with the key or wireless remote control transmitter during setting. This will cancel the system. 4. After making sure the indicator light starts flashing, you may leave the vehicle. The system will automatically be set after the preparation time passes. The indicator light will flash to show the system is set. If any of the front, sliding or back doors or hood is open at that time, the setting is interrupted until it is closed and locked. Never leave anyone in the vehicle when you set the system, because unlocking from the inside will activate the system. WHEN THE SYSTEM IS SET Activating the system The system will give the alarm under the following conditions: The alarm will activate again under the same circumstances described in "Activating the system". Stopping the alarm To stop alarm midway, do the following: D If any of the front, sliding or back doors is unlocked or if the hood is forcibly opened without the key or wireless remote control transmitter D Unlock either front door or back door with the key or wireless remote control transmitter. D If the battery terminal is disconnected and then reconnected The indicator light will come on when the system is activating. If any of the doors is unlocked without the key or wireless remote control transmitter and the key is not in the ignition switch, all the doors will be automatically locked again. After one minute, the alarm will automatically stop and the indicator light will starts flashing again. Reactivating the alarm Once set, the system cannot be cancelled without the key or wireless remote control transmitter. If the front, sliding and back doors and hood are closed after the alarm stops, the system automatically resets the alarm. D Turn the key from the "LOCK" to "ON" position. These ways cancel the system at the same time. TESTING THE SYSTEM 1. Open all the windows. 2. Set the system as described above. The doors should be locked with the key or wireless remote control transmitter. Be sure to wait until the indicator light goes off or starts flashing. 3. Unlock any door from the inside. The system should activate the alarm. 4. Cancel the system as described above. 5. Repeat this operation for the other doors and hood. When testing on the hood, also check that the system is activated when the battery terminal is disconnected and then reconnected. 33