2000 Toyota 4Runner Owners Manual - Page 105

Front drive control lever in "L4" 3RZ- FE engine "2" ...43 km/h (26 mph) "L" ...23 km/h (14 mph) 5VZ- FE engine "2" ...46 km/h (28 mph) "L" ...25 km/h (15 mph) z Do not continue hill climbing or hard towing for a long time in the "2" or "L" position. This may cause severe automatic transmission damage from overheating. To prevent such damage, "D" position should be used in hill climbing or hard towing. (f) Backing up 1. Bring the vehicle to a complete stop. 2. With the brake pedal held down with your foot, shift the selector lever to the "R" position. (g) Parking 1. Bring the vehicle to a complete stop. 2. Pull the parking brake lever fully to securely apply the parking brake. 3. With the brake pedal pressed down, shift the selector lever to the "P" position. CAUTION Always keep your foot on the brake pedal while stopped with the engine running. This prevents the vehicle from creeping. CAUTION Never attempt to move the selector lever into "P" position under any circumstances while the vehicle is moving. Serious mechanical damage and loss of vehicle control may result. (h) Good driving practice NOTICE Do not hold the vehicle on an upgrade with the accelerator pedal. It can cause the transmission to overheat. Always use the brake pedal or parking brake. D If the transmission repeatedly shifts up and down between third gear and overdrive when climbing a gentle slope, the overdrive should be turned off. Be sure to turn the switch on immediately afterward. NOTICE Never shift into reverse while the vehicle is moving. D When towing a trailer, in order to maintain engine braking efficiency, do not use overdrive. 2000 4Runner (OM35762U) 105