2000 Toyota Camry Owners Manual - Page 409

'00CAMRY CNG (L/O9908) D The gas normally produced by a battery will explode if a flame or spark is brought near. Use only standardised jumper cables and do not smoke or light a match while jump starting. JUMP STARTING PROCEDURE 1. If the booster battery is installed in another vehicle, make sure the vehicles are not touching. Turn off all unnecessary lights and accessories. 2. If required, remove all the vent plugs from the booster and discharged batteries. Lay a cloth over the open vents on the batteries. (This helps reduce the explosion hazard, personal injuries and burns.) 3. If the engine in the vehicle with the booster battery is not running, start it and let it run for a few minutes. During jump starting run the engine at about 2000 rpm with the accelerator pedal lightly depressed. Discharged battery Booster battery NOTICE The battery used for boosting must be 12 V. Do not jump start unless you are sure that the booster battery is correct. Positive Jumper terminal ("+" mark) cable Positive terminal ("+" mark) 4. Make the cable connections in the order a, b, c, d. a. Connect the clamp of the positive (red) jumper cable to the positive ( ) terminal on the discharged battery. b. Connect the clamp at the other end of the positive (red) jumper cable to the positive ( ) terminal on the booster battery. 2000 CAMRY CNG (OM33519U) 139