2000 Toyota Echo Owners Manual - Page 138

ECHO_U Before starting the engine 1. Check the area around the vehicle before entering it. 2. Adjust seat position, seatback angle, head restraint height and steering wheel angle. 3. Adjust inside and outside rear view mirrors. 4. Lock all doors. 5. Fasten seat belts. How to start the engine- (a) Before cranking 1. Apply the parking brake firmly. 2. Turn off unnecessary lights and accessories. 3. Manual transmission: Press the clutch pedal to the floor and shift the transmission into neutral. Hold the clutch pedal to the floor until the engine is started. A starter safety device will prevent the starter from operating if the clutch pedal is not fully depressed. Automatic transmission: Put the selector lever in "P". If you need to restart the engine while the vehicle is moving, put the selector lever in "N". A starter safety device will prevent the starter from operating if the selector lever is in any drive position. 4. Automatic transmission only: Depress the brake pedal and hold it to the floor until driving off. (b) Starting the engine Before starting the engine, be sure to follow the instructions in "(a) Before cranking". Normal starting procedure The multiport fuel injection system/sequential multiport fuel injection system in your engine automatically controls the proper air- fuel mixture for starting. You can start a cold or hot engine as follows: 1. With your foot off the accelerator pedal, crank the engine by turning the key to "START". Release it when the engine starts. 2. After the engine runs for about 10 seconds, you are ready to drive. If the weather is below freezing, let the engine warm up for a few minutes before driving. If the engine stalls...Simply restart it, using the correct procedure given in normal starting. If the engine will not start...See "If your vehicle will not start" in Section 4. 146 2000 ECHO (OM52411U)