2000 Toyota MR2 Spyder Owners Manual - Page 175

MR2 U Mark the direction of rotation and be sure to install them in the same direction when replacing. CHAIN INSTALLATION Install the chains on the rear tires as tightly as possible. Do not use tire chains on the front tires. Retighten chains after driving 0.5-1.0 km (1/4-1/2 mile). When installing chains on your tires, carefully follow the instructions of the chain manufacturer. NOTICE Do not attempt to use a tire chain on the compact spare tire, as it may result in damage to the vehicle as well as the tire. CAUTION D Do not drive with the snow tires incorrectly inflated. D Never drive over 120 km/h (75 mph) with any type of snow tires. TIRE CHAIN SELECTION Use the tire chains which are the correct size for your rear tires. For 205/50R15 tires, use genuine Toyota tire chains or equivalent for use on the MR2. Regulations regarding the use of tire chains vary according to location or type of road, so always check them before installing chains. CAUTION D Do not exceed 50 km/h (30 mph) or the chain manufacturer's recommended speed limit, whichever is lower. D Drive carefully avoiding bumps, holes, and sharp turns, which may cause the vehicle to bounce. braking, as use of chains may adversely affect vehicle handling. D Avoid sharp turns or locked- wheel D When driving with chains installed, be sure to drive carefully. Slow down before entering the curves to avoid losing control of the vehicle, it may cause an accident. NOTICE If the wrong combination of tire and chain is used, the chains could damage the vehicle body. D MR2 genuine tire chains (Part No.08325- 11010) 2000 MR2 (OM17475U) 193