2000 Toyota Sienna Owners Manual - Page 23

00 SIENNA(U) Wireless remote control RESETTING THE DOOR SYSTEM POWER SLIDING 1. Be sure to turn off the power sliding door system by pushing in the "PWR DOOR OFF" switch. 2. Disconnect the battery for 1 minute and then reconnect it. 3. Close the sliding door by hand. (Step 3 can be performed before step 2.) 4. Turn on the power sliding door system by pushing out the "PWR DOOR OFF" switch. 5. Wait 5 seconds. 6. Open the sliding door by using one of the "PWR DOOR" switches. 7. Wait 3 seconds after the sliding door stops at the fully −opened position. 8. Close the sliding door by using one of the "PWR DOOR" switches or wireless remote control transmitter. 9. Wait 3 seconds after the sliding door stops at the fully −closed position. 10. Repeat the steps from 6 to 9. If the power sliding door system does not operate properly after the above procedure, there may be a problem in the system. Contact your Toyota dealer. Unlocking operation Locking operation If the power sliding door system operates incorrectly or does not operate under the following conditions, the system must be initialized and reset by the steps in the next column. D The battery is disconnected and then reconnected, or a discharged battery is recharged. In this case, initialize and reset the system by doing the following steps from 6 to 10. D The open power sliding door warning light stays on though the sliding door is closed. In this case, initialize and reset the system by doing the following steps from 1 to 10. CAUTION To initialize and reset power sliding door system, stop the vehicle on a level ground. 23