2000 Toyota Solara Owners Manual - Page 280

SOLARA_U SWITCHING BEEP SOUND ON AND OFF You can switch the beep on and off. (The beep is on initially and after battery replacement.) To switch the beep on and off: With the driver's door opened- 1. Insert the ignition key and remove it. 2. Within 5 seconds, insert the ignition key again and turn it to the "ON" position. 3. Push the same "LOCK", "UNLOCK" or "PANIC" button twice within 10 seconds. Two beep sounds inform you that the program has been switched on or off. If this procedure is not followed exactly, the beep will not operate as expected. Check the beep ON/OFF operation by pushing the transmitter switch after you finish this procedure. If the beep does not operate as expected, repeat this procedure from step 1. WIRELESS REMOTE CONTROL TRANSMITTER The wireless remote control transmitter is an electronic component. Observe the following instructions in order not to cause damage to the transmitter. D Do not leave the transmitter on places where the temperature becomes high such as on the dashboard. D Do not disassemble it. D Avoid knocking it hard against other objects or dropping it. "PANIC" SWITCH Pushing the "PANIC" switch blows the horn intermittently and flashes the headlights and tail lights. The "PANIC" switch is used to deter vehicle theft when you witness anyone attempting to break into or damage your vehicle. The alarm will last for one minute. To stop alarm midway, push the "PANIC" switch once again, unlock any door with the key or transmitter, or turn the ignition key from the "LOCK" to "ON" position. The "PANIC" mode does not work when the ignition key is in the "ON" position. D Avoid putting it in water. You can use up to 4 wireless remote control transmitters for the same vehicle. Contact your Toyota dealer for detailed information. If the wireless remote control transmitter does not actuate the doors or alarm, or operate from a normal distance: 15