2001 Toyota 4Runner Owners Manual - Page 274

'01 4Runner_U (L/O 0008) Replacing light bulbs- The following illustrations show how to gain access to the bulbs. When replacing a bulb, make sure the ignition switch and light switch are off. Use bulbs with the wattage ratings given in the table. The inside of the lens of exterior lights such as headlights may temporarily fog up when the lens becomes wet in the rain or in a car wash. This is not a problem because the fogging is caused by the temperature difference between the outside and inside of the lens, just like the windshield fogged up in the rain. However, if there is a large drop of water on the inside of the lens, or if there is water pooled inside the light, contact your Toyota dealer. Light bulbs Headlights Front fog lights Parking and front side marker lights Front turn signal lights Rear turn signal lights Stop/tail lights Back−up lights License plate light High mounted stoplight Interior light Personal lights Glove box light Luggage compartment light A: B: C: D: E: Bulb No 921 - - - - W 60/55 55 5 21 21 21/5 18 5 18 8 8 1.4 8 Type A B C C D C C C C E E C E CAUTION Halogen bulbs have pressurized gas inside and require special handling. They can burst or shatter if scratched or dropped. Hold a bulb only by its plastic or metal case. Do not touch the glass part of a bulb with bare hands. NOTICE Only use a bulb of the listed type. HB2 halogen bulbs H3 halogen bulbs Wedge base bulbs (clear) Wedge base bulbs (amber) Double end bulbs 262 2001 4RUNNER (OM35768U)