2001 Toyota 4Runner Owners Manual - Page 5

'01 4Runner_U (L/O 0008) Checking power steering fluid Refilling brake fluid: 1. Turn the ignition switch off. 2. Depress the brake pedal more than 40 times. 3. Remove the reservoir cover by hand. Add brake fluid up to the "MAX" line. If you do not follow the procedure above, the reservoir may overflow. Use only newly opened brake fluid. Once opened, brake fluid absorbs moisture from the air, and excess moisture can cause a dangerous loss of braking. If hot add If hot O.K. NOTICE If you spill the fluid, be sure to wash it off with water to prevent it from damaging the parts or paint. If cold add If cold O.K. CAUTION Take care when filling the reservoir because brake fluid can harm your eyes and damage painted surfaces. If fluid gets in your eyes, flush your eyes with clean water immediately. If you still feel uncomfortable with your eyes, go to the doctor. Check the fluid level on the dipstick. If necessary, add automatic transmission fluid DEXRONr II or III. If the vehicle has been driven around 80 km/h (50 mph) for 20 minutes (a little more in frigid temperatures), the fluid is hot (60_C-80_C or 140_F-175_F). You may also check the level when the fluid is cold (about room temperature, 10_C-30_C or 50_F-85_F) if the engine has not been run for about five hours. a. Clean all dirt from outside of the reservoir tank. b. Remove the reservoir cap by turning it counterclockwise and wipe the dipstick clean. 2001 4RUNNER (OM35768U) 5